VUE AWD L4-2.2L VIN D (2005)
Important: Ensure that the seal clamp is properly positioned around the entire circumference of the seal.
3. Crimp the seal clamp using the SA9161C.
4. Measure the clamp end gap dimension. The gap should not exceed 2.15 mm (0.85 inch).
Specification
-
The gap should not exceed 2.15 mm (0.85 inch).
5. Put a light coat of grease from the service kit on the bearing roller grooves of the inner race and outer race.
6. Hold the inner race 90 degrees to centerline of cage with the lands of the inner race (1) aligned with the windows of the cage (2) and insert the
inner race into the cage.
7. Hold the cage and inner race 90 degrees to the center line of the outer race (1) and align the cage windows (3) with the lands of the outer race.
Important: Be sure that the retaining ring side of the inner race faces the wheel drive shaft bar.
