VUE AWD L4-2.2L VIN D (2005)
Fluid - M/T: Service and Repair
Transmission Fluid Checking Procedure
Transmission Fluid Checking Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
Important:
^
It is not necessary to check the fluid level unless the fluid has been changed or a leak is suspected.
^
Inspect the fluid level only when the engine is off. Ensure the vehicle is level. The transaxle must be cold.
2. Remove the fluid level check plug.
3. Verify that the fluid is level with the opening.
4. If the transaxle is not properly filled, carefully add DEXRON(r) III fluid until it begins to flow out of the fill/check plug.
5. Install the fluid level check plug.
^
Tighten the fluid level check plug to 38 Nm (28 ft. lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
6. Lower the vehicle.
