VUE AWD V6-3.5L (2007)
11. Connect the electrical connector to the EBCM.
12. Reposition the TCM, if equipped, to the mounting bracket.
13. Bleed the hydraulic brake system.
14. Turn the ignition switch to the ON position. DO NOT start engine.
15. Perform the Diagnostic System Check - Vehicle. See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Starting Point
- Vehicle
16. Observe the feel of the brake pedal after performing the diagnostic system check. If the pedal now feels spongy, air may have been in the
secondary circuit of the brake modulator assembly, which may have been introduced into the primary circuit. If the pedal feels spongy, perform the
Antilock Brake System Automated Bleed Procedure.
17. Remove the shop towel and discard into an approved container.