VUE AWD V6-3.5L (2007)
Engine Oil Pressure: Testing and Inspection
Oil Pressure Diagnosis and Testing
*
EN 46333 Oil Pressure Testing Adapter
*
SA9127E Gage Bar Set
1. Check and fill the engine oil to the proper level prior to performing the testing procedure.
2. Connect a tachometer or a scan tool.
3. Remove the engine oil pressure switch and install the EN 46333 (1), flexible hose (2) and the SA9127E (3).
Important: Shut the engine off immediately if the gage measures no oil pressure. Repair the condition before continuing. If the oil
pressure is not within specifications, inspect the oil pump.
4. Start the engine and allow it to reach normal operating temperature. Measure the engine oil pressure.
*
Engine oil temperature: 80°C (176°F)
*
Engine oil pressure - at idle speed: 70 kPa (10 psi) minimum
*
Engine oil pressure - at 3,000 RPM: 490 kPa (71 psi)
5. Low or no oil pressure may be caused by one or more of the following conditions:
*
Low engine oil level
*
Dirty or improper viscosity oil
*
Faulty oil pump
*
Worn or sticking oil pump pressure relief valve
*
Loose or damaged oil pump screen or cut O-ring seal
*
Excessive main or connecting rod bearing clearance
6. Higher than recommended oil pressure may be caused by one or more of the following conditions:
*
Worn or sticking oil pump pressure relief valve
*
Plugged oil filter
*
Improper viscosity oil
