VUE AWD V6-3.5L (2007)
Notice: Refer to Fastener Notice.
2. Install the air temperature actuator screws to the HVAC module.
Tighten the screws to 1 N.m (9 lb in).
3. Connect the electrical connector to the air temperature actuator.
Important: Any time a mode actuator or the HVAC control module is replaced, the HVAC control module must be calibrated to ensure
proper air distribution.
4. Calibrate the mode actuators by simultaneously pushing the A/C and RECIRC buttons on the HVAC control module 3 times each, within 2
seconds of initial push.
1. The A/C and RECIRC button LED's will flash while this calibration is taking place.
2. The calibration will take anywhere between 10 to 30 seconds depending on battery voltage.
3. The LEDs will quit flashing when the calibration is complete.
5. Cycle the ignition and verify proper operation.
6. Install the instrument panel compartment.
