VUE AWD V6-3.5L (2007)
Manifold Pressure/Vacuum Sensor: Service and Repair
Manifold Absolute Pressure Sensor Replacement
Removal Procedure
1. Turn the ignition OFF.
2. Disconnect the manifold absolute pressure (MAP) sensor harness connector.
3. Remove the MAP sensor attachment screw and remove the MAP sensor and O-ring (6).
Installation Procedure
Notice: Refer to Fastener Notice.
1. Make sure the MAP sensor mounting surface is clean. Install the MAP sensor with the new O-ring and attachment bolt (6).
Tighten the manifold absolute pressure sensor screw to 4 N.m (35 lb in).
2. Connect the MAP sensor harness connector. Push the connector in until the lock position is felt, then pull back to confirm engagement.