VUE AWD V6-3.5L (2007)
1. Apply a small amount of the anti-seize compound SA P/N 21485279, or equivalent, to the threads of the heated oxygen sensor.
Notice: Refer to Fastener Notice.
2. Install the bank 2 heated oxygen sensor 2 using the J 39194-C.
Tighten the oxygen sensors (exhaust manifold) to 44 N.m (33 lb ft).
3. Install the heated oxygen sensor wiring harness bracket and bolt.
Tighten the bolt to 40 N.m (30 lb ft).
4. Install the left transmission mount.
5. Lower the vehicle. Refer to Vehicle Lifting.
6. Connect the heated oxygen sensor harness connector (2). Make sure the locking tab is in the full closed position.
7. Start the engine and make sure no exhaust leaks exist.
