VUE AWD V6-35L (2007) Transmission Position Switch/Sensor Repair
6. Disconnect the PNP switch electrical connector (3) from the PNP switch (4).
7. Remove the PNP switch bolt (2) and stud (1).
8. Remove the PNP switch (4) from the transaxle.
Installation Procedure (Old Switch)
1. Make sure the transaxle manual shaft is in the Neutral position.
2. Align the flats on the park/neutral position (PNP) switch with the transaxle manual shaft and install the PNP switch.
3. Loosely install the PNP switch bolt (2) and stud (1).
4. Connect the PNP switch electrical connector (3).
Important: After adjusting the switch, verify the engine only starts in Park or Neutral. If the engine starts in any other position, adjust
the switch.