VUE AWD V6-3.5L (2007)
Knock Sensor: Service and Repair
Knock Sensor Replacement
Removal Procedure
1. Remove the lower left intake manifold.
2. Disconnect the wiring harness connector from the knock sensor (KS).
3. Remove the KS from the engine block.
Installation Procedure
Notice: Refer to Fastener Notice.
Important: DO NOT apply thread sealant to the sensor threads. The sensor threads are coated at the factory and applying additional
sealant affects the sensors ability to detect detonation.
1. Install the KS into engine block.
Tighten the KS to 31 N.m (23 lb ft).
2. Connect the KS wiring harness connector to the knock sensor.
3. Install the lower left intake manifold.