VUE AWD V6-3.5L (2007)
10. Install the shift control cable and retaining clip (2) to the shift control cable bracket (1).
11. Install the shift control cable (3) to the range select lever (4).
12. Verify proper operation of the shift control cable and if necessary adjust the cable.
1. Place the shift lever in N (Neutral). Rotate the selector shaft clockwise from P (Park) through R (Reverse) into N (Neutral).
2. With the shift control assembly in N (Neutral) lift the cable connector locking clip up.
3. Push the clip on the cable connector until fully seated and flush with cable body.
Installation Procedure (New Switch)
Important: After adjusting the switch, verify the engine only starts in Park or Neutral. If the engine starts in any other position, adjust
the switch.
1. Make sure the transaxle manual shaft is in the Neutral position.
2. Align the flats on the PNP switch with the transaxle manual shaft and install the PNP switch.
Notice: Refer to Fastener Notice.
3. Install the PNP switch bolt (2) and stud (1).
Tighten the bolt and stud to 20 N.m (15 lb ft).
4. Connect the PNP switch electrical connector (3).
