VUE AWD V6-3.5L (2007)
9. Install the transmission side cover (1) to the transmission case.
Notice: Refer to Fastener Notice.
10. Install the transmission side cover bolts (3) and studs (4).
Tighten the bolts and studs to 28 N.m (22 lb ft).
11. Install the output axle seal and sleeve.
12. Lower the vehicle.
13. Raise the engine and transmission with the engine support fixture.
14. Install the transmission mount.
15. Raise the vehicle.
16. Install the frame bolts.
17. Install the rear transmission mount to frame bolts.
Tighten the bolts to 50 N.m (37 lb ft).
18. Install the front transmission mount.
19. Install the power steering gear intermediate shaft pinch bolt.
20. Install the left wheel drive shaft to the transmission.
21. Connect the left ball joint to the steering knuckle.
22. Connect the left tie rod to the steering knuckle.
23. Connect the left stabilizer shaft link to the stabilizer shaft.
24. Install the left front splash shield.
25. Install the left front tire and wheel.
26. If equipped with 2.4L (LAT), install the auxiliary fluid pump.
27. Lower the vehicle. Refer to Vehicle Lifting.
28. Untie the radiator, air conditioning condenser, and fan module assembly.
29. Remove the engine support fixture.
30. Install the PNP switch.
