VUE AWD V6-3.5L (2007)
Parking Lock Cable: Service and Repair
Park Lock Cable Replacement
Removal Procedure
Important: The park lock cable clips and park lock cable end fittings are one time usage only. Any service repair requiring the park lock
cable to be disconnected from the ignition module or shift control will require replacement of the cable clip and/or cable end fitting.
1. Disable the SIR system.
2. Remove the left console trim panel.
3. Remove the lock cylinder bezel from the steering column shroud by carefully prying with a thin bladed screwdriver.
4. Remove the shroud fasteners and remove the steering column upper and lower shroud panels.
5. Make sure the key is in the OFF position.
6. Squeeze the tabs on the park lock cable clip and pull upward to remove the cable from the shift control. Discard the park lock cable clip.
7. Disconnect the park lock cable from the shift control park lock lever.
