VUE AWD V6-3.5L (2007)
5. With the cable adjuster in the unlocked position, verify the shift control is in the park (P) position. Lock the adjuster piece into place by pushing in
on the tab, then check the cable adjustment as follows:
1. Set the parking brake.
2. With the ignition key removed from ignition lock cylinder and control shift lever in the park (P) position, depress the control shift lever
button and attempt to move control shift lever out of park (P) position.
*
If control shift lever can be shifted out of park (P) position, perform step 5 over again ensuring that the cable adjuster lock is operating
properly.
*
If control shift lever cannot be shifted out of park (P) position, proceed to next step.
3. Insert the ignition key into the ignition lock cylinder assembly and turn to RUN position.
4. Depress the brake pedal and depress the control shift lever button and move control shift lever out of park (P) position.
5. Release the brake pedal. With the control shift lever out of the park (P) position, attempt to turn ignition to LOCK position. Ensure the
ignition key is pushed inward toward the steering column when it is rotated toward LOCK position.
*
If ignition key can be turned to LOCK position with control shift lever out of park (P) position, return to the beginning of step 5 and
check the park lock cable adjustment.
*
If the ignition key cannot be turned to LOCK position with the control shift lever out of the park (P) position, park lock cable is
properly adjusted. Proceed to next step.
6. Depress the control shift lever button. Move control shift lever to park (P) position.
7. Turn the ignition key to ON position and then to OFF position.
8. Ensure ignition key is removable.
*
If ignition key can be removed from ignition lock cylinder assembly, proceed to next step.
*
If ignition key cannot be removed from ignition lock assembly, return to the beginning of step 5 and check the park lock cable
adjustment.
9. Turn the ignition key to LOCK position.
10. Remove the ignition key from the ignition lock cylinder assembly.
6. Install the shroud fasteners and install the steering column upper and lower shroud panels.
7. Install the lock cylinder bezel onto the steering column shroud.
8. Install the left console trim panel.
9. Enable the SIR system.
