VUE AWD V6-3.5L (2007)
Important: The output axle shaft sleeve and seal must be replaced together. DO NOT replace the sleeve or seal separately.
1. Use the J 41228 to install a new sleeve on the output axle shaft. Ensure that the collet is located in the retaining ring groove when installing.
2. Install the new output axle seal using the J 41102-1A and a mallet.
3. Install a NEW retaining ring on the output shaft.
4. Install the left drive axle assembly.
5. Lower the vehicle.
6. Inspect the output axle shaft sleeve for leaks.
7. Inspect the transmission oil level.
Stub Axle Shaft Sleeve and Seal Replacement
Stub Axle Shaft Sleeve and Seal Replacement
Tools Required
*
J 38868 Gear Installer Remover
*
J 6125-1B Slide Hammer
*
J 23129 Axle Boot Remover
*
J 41102-1A Axle Seal Installer
Removal Procedure
1. Remove the right drive axle assembly.