VUE AWD V6-3.5L (2007)
Transmission Speed Sensor: Service and Repair
Output Speed Sensor Replacement
Output Speed Sensor Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the wiring harness from the output speed sensor.
Important: Do not damage the output speed sensor or transaxle case.
3. Remove the output speed sensor bolt/screw.
4. Remove the output shaft speed sensor and the O-ring.
Installation Procedure
1. Apply automatic transmission fluid to the new output speed sensor O-ring seal.
2. Install the new output speed sensor O-ring seal onto the output speed sensor.
3. Install the output speed sensor into the transmission case assembly.
Notice: Refer to Fastener Notice.
4. Install the output speed sensor bolt.
Tighten the bolt to 12 N.m (106 lb in).
5. Connect the wiring harness to the output speed sensor.
