VUE AWD V6-3.5L (2007)
Wiring Harness: Service and Repair
4T45-E - Automatic Transaxle
Wiring Harness Replacement
Tools Required
J 41101 Transaxle Connector Remover
Removal Procedure
1. Remove the transmission from the vehicle.
2. Remove the transmission side cover.
3. Remove the control valve body.
4. Push the J 41101 onto the pass-through connector from the outside of the transmission case in order to compress the pass-through connector's
retaining tabs.
5. With the retaining tabs compressed, use a screwdriver in order to remove the pass-through connector through the inside of the transmission case.
6. Remove the wiring harness (11).
Installation Procedure
1. Connect the wiring harness assembly to the following components:
*
The TFP switch assembly (13)
*
The pressure control solenoid (312) (red connector)
Important: The 1-2 shift solenoids wires are red and light green. The 2-3 shift solenoid wires are red and yellow.
*
The 1-2 shift solenoid (305) (white connector)
*
The 2-3 shift solenoids (305) (white connectors)
*
The TCC solenoid (335)
2. Install the control valve body.
3. Install the transmission side cover.