VUE AWD V6-3.5L VIN 4 (2004)
9. Verify the VIN on the Validate Vehicle Identification Number screen.
10. Select Next.
11. If an option screen appears, verify the vehicle configuration and/or RPO information.
12. Select Next.
13. Highlight the appropriate control module and programming type on the Support Controllers screen.
14. Select Next.
IMPORTANT: Select Cancel if you receive a message stating that the calibration selected is already the current calibration in the control
module and reprogramming with the same download is not allowed.
15. Select the proper calibrations on the Calibration Selection screen.
16. Ensure all the folder tabs have a green check mark.
17. Select Next.
18. Verify the current calibrations with the selected calibrations.
19. Select Next.
20. The Transfer Data screen will appear until the progress bar reaches 100 percent. This may take up to 30 minutes.
21. Complete all of the terminal-directed data on the Programming Complete screen.
IMPORTANT: Some vehicles will require that Idle Learn, Theft Deterrent Relearn, or Crankshaft Variation Learn procedures be
performed after programming. Consult the appropriate service information for these procedures.
22. Turn OFF the Tech 2.
23. Disconnect the Tech 2 from the vehicle.
