VUE AWD V6-3.5L VIN 4 (2004)
Important:
Passenger's door shown, driver's door similar.
Important:
Push nuts to be replaced are the ones for the upper and lower door pull handle.
16.
Using 90° needle nose pliers, enter access hole near each pushnut to be replaced. Depress tabs on pushnut from inside door structure and remove
pushnut. Discard old pushnuts.
17.
Install new pushnut, P/N 11518162, into door structure by pushing them into door frame opening (tabs should be on left and right of opening).
Important:
Repeat step 17 for other pushnut.
18.
Reinstall inner door water deflector making sure there are no gaps in the sealer.
19.
Position door trim panel over top of door hooks structure.
20.
Push downward to engage door trim panel hooks to structure.
21.
Install fastener located at the bottom of door trim panel.
Tighten
Tighten Door Trim Panel Lower Fastener to 2.5 N.m (22 in-lbs).
22.
Install fasteners located behind door trim pull handle.
Tighten
Tighten Door Trim Panel Fasteners to 2.5 N.m (22 in-lbs)
23.
Snap inside door pull handle escutcheon into place.
