VUE AWD V6-3.5L VIN 4 (2004)
11. Gently pull down the left rear corner of the headliner to access the roof rail module-left connector.
12. Remove the connector position assurance (CPA) from the roof rail module-left connector.
13. Disconnect the roof rail module-left connector from the vehicle harness connector.
14. Remove the lower center pillar trim.
15. Remove the CPA from the seat belt pretensioner-LF connector.
16. Disconnect the seat belt pretensioner-LF connector.
ENABLING PROCEDURE
1. Remove the key from the ignition switch.
2. To enable the roof rail module-left, perform steps 3-8. To enable both the roof rail module-left and the seat belt pretensioner-LF, continue to step
3.
