VUE AWD V6-3.5L VIN 4 (2004)
2.
Remove the wheel nuts retaining the brake rotor to the hub.
3.
Install the tire and wheel assembly.
4.
Repeat Steps 1-3 on opposite side brake assembly.
5.
Lower the vehicle.
6.
With the engine OFF, gradually apply the brake pedal approximately 2/3 of its travel distance.
7.
Slowly release the brake pedal.
8.
Wait 15 seconds, then gradually apply the brake pedal approximately 2/3 of its travel distance again until a firm brake pedal apply is obtained.
This will properly seat the brake caliper pistons and brake pads.
Parts Information
Warranty Information
For vehicles repaired under warranty, use the table.
Disclaimer
