VUE AWD V6-3.5L VIN 4 (2004)
1. Start the engine and command the fuel pump OFF with the scan tool. Refer to Scan Tool Output Controls.
2. Run the engine until the engine stalls.
3. Use the drain hose (3) of the fuel shut off and bleed assembly (5) in order to drain any remaining fuel from the gage, the lines, and the hoses.
4. Disconnect the gage hose (1) from the fuel shut off and bleed assembly (5).
5. Remove the fuel shut off and bleed assembly (5) from the fuel feed pipe (4). Use a shop towel in order to catch any remaining fuel that may leak.
6. Install the schrader valve cap in order to protect the fitting from dirt and contaminants.
7. Install the intake air duct to the engine.
8. Perform the idle learn procedure. Refer to Idle Learn Procedure.
