VUE AWD V6-3.5L VIN 4 (2004)
Fluid - A/T: Service and Repair
Transmission Fluid Replacement
1. Start the engine until the transmission fluid temperature reaches 60-70°C (140-158°F).
2. Raise and support the vehicle.
3. Remove the drain plug from the transmission. Allow the fluid to completely drain.
4. Remove the gasket from the drain plug and discard.
5. Install the new gasket on the drain plug.
Notice: Refer to Fastener Notice in Cautions and Notices.
6. Install the drain plug into the transmission.
-
Tighten the drain plug to 49 Nm (36 ft. lbs.).
7. Lower the vehicle.
8. Remove the outlet resonator/duct assembly.
9. Remove the transmission fill plug.
Important: Do not use ATF (P/N 21005966 or P/N 21019223). These fluids are not compatible with this transmission.
10. Add approximately 2.7 Liters (2.9 Qt) of Saturn ATF-Z 1 fluid (P/N 22717466) through the transmission fill plug.
11. With the vehicle on a flat level surface, start the engine and operate until the transmission fluid temperature reaches 60-70°C (140-158°F).
12. Apply the parking brake.
13. Depress the brake pedal and move the shift lever slowly through all gear ranges, pausing approximately 3 seconds in each range.
14. Return the shift lever to the park position.
15. Turn the engine OFF.
16. Pull the transmission level indicator from the transmission in order to check the proper fluid level on the gage.
17. If the fluid is not within the proper range, adjust as necessary.
