saturn Workshop Repair Guides

Saturn Workshop Service and Repair Manuals

OnStar(R) - Generation 6 Service Procedures|Page 223 > < OnStar(R) - Generation 6 Service Procedures|Page 221
Page 24
background image

DTC B2483: Global Positioning System (GPS) Antenna Malfunction Short to Ground

DTC B2484: Global Positioning System (GPS) Antenna Malfunction Open Circuit

Conditions for Running the DTCs

The ignition is in RUN or ACC position

System voltage is between 9.5 - 15.5 volts.

The above conditions are met for more than 1 second.

Conditions for Setting the DTCs

B2462 02: The CIM detects a short to ground on the navigation antenna signal circuit.

B2462 04: The CIM detects an open/high resistance on the navigation antenna signal circuit.

B2483: The CIM detects a short to ground on the navigation antenna signal circuit.

B2484: The CIM detects an open/high resistance on the navigation antenna signal circuit.

Action Taken When the DTCs Set

The OnStar(R) status LED turns red.

The OnStar(R) Call Center cannot locate the vehicle.

Conditions for Clearing the DTCs

The condition responsible for setting the DTC no longer exists.

A history DTC will clear once 50 consecutive malfunction-free ignition cycles have occurred.

Circuit/System Testing

Turn OFF the ignition.

1. Disconnect the navigation antenna coax cable from the VCIM.

2. Ignition ON, test for 4.5-5.5 volts between the VCIM coax cable center conductor terminal at the VCIM and ground.

^

If not within the specified range, replace the VCIM. Refer to the appropriate vehicle in SI.

3. Reconnect the coax cable to the VCIM.

4. Disconnect the coax cable from the navigation antenna.

5. Test for 4.55.5 volts between the coax cable center conductor and the outer shield.

^

If not within the specified range, replace the coax cable.

6. If all circuits test normal, replace the navigation antenna. Refer to the appropriate vehicle in SI.

DTC B2470

DTC Descriptor

DTC B2470 04: Cellular Phone Antenna Circuit Malfunction Open Circuit

Circuit/System Description

The cellular antenna is connected to the vehicle communication interface module (VCIM) with an RG-58 coax cable. The VCIM collects the data from
the cellular antenna once every second.

OnStar(R) - Generation 6 Service Procedures|Page 223 > < OnStar(R) - Generation 6 Service Procedures|Page 221