VUE AWD V6-3.5L VIN 4 (2004)
Electronic Brake Control Module: Service and Repair
Electronic Brake Control Module (EBCM) Replacement
Removal Procedure
Notice: Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to
observe this precaution could result in damage to the EBCM/EBTCM.
1. Remove the transmission control module (TCM), if equipped, from the mounting bracket and position aside.
2. Turn the ignition switch to the OFF position.
3. Clean the electronic brake control module (EBCM) to brake pressure modulator valve (BPMV) area of any accumulated dirt and foreign material.
4. Disconnect the electrical connector from the EBCM.
5. Disconnect the pump motor electrical connector.
6. Remove the EBCM attaching screws.