VUE AWD V6-3.5L VIN 4 (2004)
2. Connect the I/P module connector to the vehicle harness connector.
3. Install the CPA to the I/P module connector.
4. Install the AIR BAG fuse into the body control module fuse center.
5. Install the body control module fuse center cover.
6. Use caution while reaching in and turn the ignition switch to the ON position.The AIR BAG indicator will flash then turn OFF.
7. Perform the SIR Diagnostic System Check if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check -
Restraint Systems.
SIR Disabling and Enabling Zone 6
SIR DISABLING AND ENABLING ZONE 6
DISABLING PROCEDURE
1. Turn the steering wheel so that the vehicles wheels are pointing straight ahead.
2. Turn the ignition switch to the OFF position.
3. Remove the key from the ignition switch.
4. Locate the body control module fuse center, then remove the fuse center cover.
5. Locate and remove the AIR BAG fuse from the body control module fuse center.
IMPORTANT: With the AIR BAG fuse removed and the ignition switch in the ON position, the AIR BAG warning indicator illuminates. This is
normal operation, and does not indicate an SIR system malfunction.
6. To disable the roof rail module-right, perform steps 7-13. To disable both the roof rail module-right and the seat belt pretensioner-RF, continue to
step 7.
7. Remove the upper rear window molding.
8. Remove both the left and right rear corner garnish moldings.
9. Remove the rear headliner push-in retainers.
10. Remove the rear coat hooks.
11. Gently pull down the right rear corner of the headliner to access the roof rail module-right connector.
