VUE AWD V6-3.5L VIN 4 (2004)
Fluid Pressure Sensor/Switch: Service and Repair
4TH Clutch Pressure Switch Replacement
4th Clutch Pressure Switch Replacement
Removal Procedure
1. Remove the battery tray.
2. Disconnect the wiring harness from the 4th clutch pressure switch.
3. Remove the 4th clutch pressure switch and washer.
Installation Procedure
Notice: Refer to Fastener Notice in Cautions and Notices.
1. Install the 4th clutch pressure switch and washer.
-
Tighten the input speed sensor bolt 20 Nm (114 ft. lbs.).
2. Connect the wiring harness to the 4th clutch pressure switch.
3. Install the battery tray.
