VUE AWD V6-3.5L VIN 4 (2004)
16. Pivot the CV joint cage (4) and the inner race 90 degrees to the centerline of the outer race (2). At the same time, align the cage windows (3) with
the lands of the outer race.
17. Lift out the cage (4) and the inner race.
18. Remove the inner race (1) from the cage (2) by rotating the inner race upward.
19. Clean the following items thoroughly with a suitable solvent. Remove all traces of grease and contaminants.
-
The inner and outer race assemblies
-
The CV joint cage
-
The bearing rollers
20. Dry all the parts with compressed air.
21. Inspect the CV joint assembly for the following:
-
Unusual wear
-
Cracks
-
Damage
22. Replace any damaged parts.
23. Clean the wheel drive shaft bar. Use a wire brush to remove any rust in the seal mounting grooves.
Installation Procedure
