VUE FWD L4-2.4L (2008)
Important: Before using EN 45680-881 trim tool assembly, the height of the cutting blades must be set to the proper specification. The
proper specification is that the cylinder bore sleeve flange must be flush to +0.02 mm (0.0008 in) above the block deck surface.
5. The groove side of the EN 45680-882 set gage ring (1) should be positioned upward on a flat surface.
Important: Ensure that the EN 45680-882 set gage ring surfaces are clean.
6. Carefully position EN 45680-881 trim tool assembly onto the EN 45680-882 set gage ring.
7. Loosen the shaft collar screw (2).
8. Push the shaft collar (2) downward using the trim tool preloader (1) until the shaft collar is positioned against the top of the flange bearing (3).
Important: Once this procedure is done, it is not necessary to reset the EN 45680-881trim tool assembly height until the blades are worn
or damaged.
9. Apply downward pressure on the collar and inner drive shaft using the trim tool preloader (1), then tighten the shaft collar screw.
Tighten the shaft collar screw to 19 N.m (14 lb ft).
