VUE FWD L4-2.4L (2008)
1. Install the NEW oil filter to the cap.
2. Install the oil filter cap and filter.
Notice: Over torquing the oil filter cap may cause damage to the oil filter cap resulting in an oil leak.
Important: DO NOT use an open end wrench on the hex on top of the oil filter cap.
3. Use a 32 mm (1 1/4 in) socket on the hex on the top of the oil filter cap, or an oil filter wrench on the outside diameter of the oil filter cap .
Tighten the oil filter cap until fully seated. DO NOT exceed 25 N.m (18 lb ft).
4. Fill the engine with oil. Refer to Fluid and Lubricant Recommendations (See: Maintenance/Service Intervals) .
