VUE FWD L4-2.4L (2008)
1. Remove the snap ring.
2. Remove the piston assembly from the body of the timing chain tensioner.
3. Install the J 45027-2 (2) into a vise.
4. Install the notch end of the piston assembly into the J 45027-2 (2).
5. Using the J 45027-1 (1), turn the ratchet cylinder into the piston.
6. Reinstall the piston assembly into the body of the tensioner.
7. Install the snap ring.
27. Inspect the timing chain tensioner seal for damage. If damaged, replace the seal.
28. Inspect to ensure all dirt and debris is removed from the timing chain tensioner threaded hole in the cylinder head.
Important: Ensure the timing chain tensioner seal is centered throughout the torque procedure to eliminate the possibility of an oil leak.
29. Install the timing chain tensioner assembly.
Tighten the timing chain tensioner to 75 N.m (55 lb ft).
30. The timing chain tensioner is released by compressing it 2 mm (0.079 in), which will release the locking mechanism in the ratchet. To release the
timing chain tensioner, use a suitable tool with a rubber tip on the end. Feed the tool down through the cam drive chest to rest on the cam chain.
Then give a sharp jolt diagonally downwards to release the tensioner.
