VUE FWD L4-2.4L (2008)
1. Align the air temperature actuator with the door shaft and rotate into position.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
2. Install the air temperature actuator screws to the HVAC module.
Tighten the screws to 1.5 N.m (13 lb in).
3. Connect the electrical connector to the air temperature actuator.
Important: Any time an actuator or the HVAC control module is replaced, the HVAC control module must be calibrated to ensure
proper air distribution.
4. Calibrate the actuators. Refer to Actuator Recalibration (See: Testing and Inspection/Programming and Relearning) .
5. Cycle the ignition and verify proper operation.
6. Install the instrument panel compartment. Refer to Instrument Panel Compartment Replacement (See: Body and Frame/Interior Moulding /
Trim/Glove Compartment/Service and Repair) .
Mode Actuator Replacement
Mode Actuator Replacement
Removal Procedure
