VUE FWD L4-2.4L (2008)
^
If a fluid leak is not present, proceed to Step 2.
2.
Raise vehicle on a hoist. Refer to Lifting and Jacking the Vehicle in SI.
3.
Remove the right front wheel to gain access to the power steering pump high pressure output line. Refer to Tire and Wheel Removal and
Installation in SI.
Important:
Inspect the bottom side of the power steering reservoir and high pressure output line for evidence of a fluid leak. Clean the affected area, if
required.
4.
Using a 16 mm open-end wrench, loosen the high pressure line tube nut (1). Do not remove the tube nut from the power steering pump.
5.
Fully tighten the tube nut (1) by hand.
6.
Note the position of the tube nut flats (2).
7.
Using a 16 mm open-end wrench, tighten the tube nut (1) 60-90 degrees (about 1 to 1-1/2 hex flats). Do not tighten the tube nut more than 90
degrees (1-1/2 hex flats).
8.
Install the right front wheel. Refer to Tire and Wheel Removal and Installation in SI.
9.
Lower the vehicle. Refer to Lifting and Jacking the Vehicle in SI.
10.
If a power steering leak was found in Step 2 or 4, check the power steering fluid and add fluid if required. Refer to Checking and Adding Power
Steering Fluid in SI.
Courtesy Transportation
The General Motors Courtesy Transportation program is intended to minimize customer inconvenience when a vehicle requires a repair that is covered
by the New Vehicle Limited Warranties. The availability of courtesy transportation to customers whose vehicles are within the warranty coverage period
and involved in a product program is very important in maintaining customer satisfaction. Dealers are to ensure that these customers understand that
shuttle service or some other form of courtesy transportation is available and will be provided at no charge. GM dealers should refer to the General
Motors Service Policies and Procedures Manual for Courtesy Transportation guidelines. Saturn Canada retailers should refer to applicable Home Office
letter on this subject.
Claim Information - GM, Saturn Canada Only