VUE FWD L4-2.4L (2008)
1. If necessary, coat the threads of the HO2S with anti-seize compound Saturn P/N 21485279 or equivalent.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
2. Install the HO2S using wrench J 39194-C .
Tighten the sensor to 42 N.m (31 lb ft).
3. Install the HO2S wiring in the exhaust heat shield.
4. Connect the engine wiring harness electrical connector to the HO2S electrical connector.
5. Install the CPA tab to the HO2S electrical connection.
