VUE FWD L4-2.4L (2008)
Fuel Supply Line: Service and Repair
Fuel Hose/Pipes Replacement - Chassis
Removal Procedure
Caution: Ensure that the vehicle is properly supported and squarely positioned. To help avoid personal injury when a vehicle is on a hoist, provide
additional support for the vehicle on the opposite end from which the components are being removed.
Caution: Do not allow smoking or the use of open flames in the area where work on the fuel or EVAP system is taking place. Anytime work is being
done on the fuel system, disconnect the negative battery cable, except for those tests where battery voltage is required.
Caution: Whenever fuel lines are removed, catch fuel in an approved container. Container opening must be a minimum of 300 mm (12 in) diameter to
adequately catch the fluid.
Notice: Fuel/Vapor lines cannot be spliced or repaired. The line must be replaced (if damaged) with the same type of line.
1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief (With CH 48027-100) (See: Fuel Filter/Fuel Pressure Release/Service and
Repair/Fuel Pressure Relief (With CH 48027-100))Fuel Pressure Relief (Without CH 48027-100) (See: Fuel Filter/Fuel Pressure Release/Service
and Repair/Fuel Pressure Relief (Without CH 48027-100)) .
2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (With LAT-2.4L) (See: Starting and
Charging/Battery/Battery Cable/Service and Repair)Battery Negative Cable Disconnection and Connection (Without LAT-2.4L) (See: Starting
and Charging/Battery/Battery Cable/Service and Repair) .
3. Disconnect the chassis fuel feed line quick connect fitting (3) from the fuel rail. Refer to Metal Collar Quick Connect Fitting Service (See: Fuel
Line Coupler/Service and Repair/Metal Collar Quick Connect Fitting Service) .
4. Disconnect the chassis evaporative emission (EVAP) line quick connect fitting (2) from the EVAP canister purge solenoid valve. Refer to Plastic
Collar Quick Connect Fitting Service (See: Fuel Line Coupler/Service and Repair/Plastic Collar Quick Connect Fitting Service) .
5. Remove chassis fuel feed line clip (1) from the fuel line bracket.
