VUE FWD L4-2.4L (2008)
Important: Inspect the exhaust CMP sensor for damage, replace as necessary.
1. Lubricate the exhaust CMP sensor O-ring seal with clean engine oil.
2. Install the exhaust CMP sensor. (Intake CMP shown, exhaust CMP similar).
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
3. Install the exhaust CMP sensor bolt.
Tighten the bolt to 10 N.m (89 lb in).
4. Connect engine wiring harness electrical connector (1) to the exhaust CMP sensor.
