VUE FWD L4-2.4L (2008)
1. Lubricate the CKP sensor O-ring seal with clean engine oil.
2. Install the CKP sensor.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
3. Install the CKP sensor bolt.
Tighten the bolt to 10 N.m (89 lb in).
4. Connect the engine wiring harness electrical connector (1) to the CKP sensor.
5. Install the starter motor. Refer to Starter Motor Replacement (LE5 2.4L and LAT-2.4L) (See: Starting and Charging/Starting System/Starter
Motor/Service and Repair).
