VUE FWD L4-2.4L (2008)
6. Remove and discard the lower ball joint cotter pin.
7. Loosen the ball stud nut, until level with the top of the ball stud.
8. Using the J-42188-B , separate the lower ball joint from the steering knuckle.
9. Remove the lower control arm and nut.
Important: Do not free the ball stud from the steering knuckle by use of a pickle fork or a wedge type tool. Damage to the seal or bushing
may result. Tip
10. Remove the tie rod. Refer to Steering Linkage Outer Tie Rod Replacement (See: Steering/Tie Rod/Service and Repair/Steering Linkage Outer Tie
Rod Replacement) .
