VUE FWD L4-2.4L (2008)
3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair) .
4. Position a drain pan under the transaxle cooler pipes.
5. Remove the transaxle oil cooler pipe retaining nut from the transaxle.
6. Remove the transaxle oil cooler pipe from the transaxle.
7. Remove the lower transaxle oil cooler pipe fitting at the radiator.
8. Remove the transaxle oil cooler pipe retaining clip from the radiator.
9. Remove the transaxle oil cooler pipes from the vehicle.
Installation Procedure
1. Install the transaxle oil cooler pipes to the vehicle.
2. Fasten the transaxle oil cooler pipe retaining clip to the radiator
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
Important: The correct thread engagement is critical. Crossthreaded fittings can achieve proper tightness value and still leak.
3. Install the lower transaxle oil cooler pipe fitting to the radiator.
Tighten the fitting to 16 N.m (12 lb ft).
4. Install the transaxle oil cooler pipes to the transaxle.
5. Install the transaxle oil cooler pipe retaining nut.
Tighten the nut to 4 N.m (27 lb in).
6. Lower the vehicle.
7. Install the upper transaxle oil cooler pipe fitting to the radiator.
Tighten the fitting to 16 N.m (12 lb ft).
8. Install the battery box. Refer to Battery Tray Replacement (2.4L LAT-2.4L) () .
Notice: Do NOT overfill the transaxle. The overfilling of the transaxle causes foaming, loss of fluid, shift complaints, and possible damage to the
transaxle.
9. Adjust the transmission fluid level. Refer to Transmission Fluid Check (See: Testing and Inspection/Component Tests and General
Diagnostics/4T45-E - Automatic Transaxle/Transmission Fluid Check) .
10. Inspect for fluid leaks.
Oil Feed Pipes Replacement
Oil Feed Pipes Replacement
Removal Procedure
1. Remove the transmission oil filter assembly. Refer to Automatic Transmission Fluid Filter and Seal Replacement (See: Fluid Filter - A/T/Service
