VUE FWD L4-2.4L (2008)
Windshield Washer Hose: Customer Interest
Wipers/Washers - Reduce Windshield Washer Fluid Flow
TECHNICAL
Bulletin No.: 08-08-43-004
Date: March 11, 2008
Subject:
Reduced Windshield Washer Flow (Reroute Chafed Washer Hose)
Models:
2008 Saturn VUE
Condition
Some customers may comment on a reduced windshield washer flow.
Cause
For vehicles built prior to August 3rd, 2007, this may be caused by a chafed washer hose under the cowl vent.
Correction
Currently there are two designs for the washer hose routing. Determine which design the vehicle has using the procedure below.
1.
Inspect the washer hose for correct routing.
^
If the routing is as shown above (First design) refer to Step 2.
^
If the routing is as shown above (Second design) the condition is not due to a chafed hose - continue with normal diagnosis.
2.
Remove the air inlet grille panel. Refer to Air Inlet Panel Replacement in SI.
3.
Using an 8 mm (5/16 in) drill bit, drill a hole into the air inlet panel. Measure over from old location (1), 100 mm (4 in) to the new location (2).
4.
Replace the damaged section of washer hose and re-route the hose to avoid future damage.
5.
Reinstall the air inlet panel. Refer to Air Inlet Panel Replacement in SI.
