VUE FWD L4-2.4L Hybrid (2007)
Tighten the liftgate latch bolts to 12 N.m (9 lb ft).
4. Install liftgate lock cylinder.
5. Install the crank by sliding the latch to crank rod into the crank.
6. Install the crank bolts.
Tighten the crank bolts to 12 N.m (9 lb ft).
Important: Check for proper adjustment of outside handle rod. There should be no tension on the pivot or liftgate latch.
7. Adjust the outside handle rod to freely enter the clamshell-style retainer clip in the crank and snap into place.
8. Check the function of the latch by doing the following:
* Reset the liftgate latch by inserting a screwdriver into the mouth of the latch.
* Pull outside handle.
* If outside handle does not actuate the latch, adjust the outside handle rod's position inside the clamshell-style retainer clip.
9. Connect the electrical connector, if equipped, to the liftgate latch.
10. Install the liftgate trim panel.
11. Close the liftgate.
