VUE FWD L4-2.4L Hybrid (2007)
17. With the left rear wheel hydraulic circuit bleeder valve tightened securely, and after all air has been purged from the left rear hydraulic circuit,
install a proper box-end wrench onto the RIGHT FRONT wheel hydraulic circuit bleeder valve.
18. Install a transparent hose over the end of the bleeder valve, then repeat steps 13-14.
19. After completing the final wheel hydraulic circuit bleeding procedure, ensure that each of the 4 wheel hydraulic circuit bleeder valves is properly
tightened.
20. Close the J 29532, or equivalent, fluid tank valve, then disconnect the J 29532, or equivalent, from the J 44894-A.
21. Remove the J 44894-A from the brake master cylinder reservoir.
22. Slowly depress and release the brake pedal. Observe the feel of the brake pedal.
23. If the brake pedal feels spongy perform the following steps:
1. Inspect the brake system for external leaks.
2. If equipped with antilock brakes, using a scan tool, perform the antilock brake system automated bleeding procedure to remove any air that
may have been trapped in the brake pressure modulator valve (BPMV).
24. Turn the ignition key ON, with the engine OFF. Check to see if the brake system warning lamp remains illuminated.
Important: DO NOT allow the vehicle to be driven until it is diagnosed and repaired.
25. If the brake system warning lamp remains illuminated. Refer to Symptoms - Hydraulic Brakes. See: Testing and Inspection/Symptom Related
Diagnostic Procedures/Symptoms - Hydraulic Brakes
