VUE FWD L4-2.4L Hybrid (2007)
Tighten the bolt to 10 N.m (89 lb in).
75.
Install the rear compartment closeout panels.
76.
Connect the 12-volt negative battery cable.
77.
Reprogram the ECM with the latest calibrations if a P1A5A DTC was stored with the P1A59 DTC.
78.
After programming, clear any DTC codes that may be present.
79.
CALIFORNIA, MASSACHUSETTS, MAINE, & VERMONT VEHICLES ONLY: Install a Recall Identification Label. Also, for California
vehicles complete a "Proof of Correction" certificate upon recall completion.
80.
Refer to section titled "Returning the Battery".
Battery Cassette Replacement - AURA
Battery Cassette Replacement - AURA
Important:
Dust may be an irritant to skin and eyes. Avoid skin and eye contact. If battery dust is present, remove carefully to avoid inhalation. Wear
safety glasses and butyl rubber, natural rubber, neoprene, nitrile or Tyvek protective gloves when handling any corroded hybrid batteries and
when cleaning the inside of the hybrid battery case. Discard the gloves after each use and dispose of any corrosion material that was removed
from the case.
1.
Remove the ignition key from the ignition switch. Secure the ignition key in order to ensure that the key CANNOT be reinstalled without your
knowledge.
2.
Disconnect the 12-volt negative battery cable.
3.
Fold down both rear seat backs.
4.
Carefully lift up on the load floor rear compartment cover (1) at the retaining clip (2) locations.
