saturn Workshop Repair Guides

Saturn Workshop Service and Repair Manuals

Scan Tool Does Not Communicate with Class 2 Device|Page 6789 > < Scan Tool Does Not Communicate with Class 2 Device|Page 6787
Page 3
background image

Step 12 - Step 19

The numbers below refer to the step numbers on the diagnostic table.

2. A partial loss of communication in the class 2 serial data circuit uses a different procedure than a total loss of communication of the class 2 serial

data circuit.

4. The following DTCs may be retrieved with a history status. These DTCs are not the cause of the present condition.

*  U1300
*  U1301

6. A State of Health DTC with a history status may be present along with a U1000 with a current status. This indicates that the malfunction occurred

when the ignition was ON.

10. This step will isolate a wiring problem or a module malfunction.
12. This step analyzes the impact of each connected module to class 2 bus.
18. If there are no current DTCs that begin with the letter "U", the communication concern has been repaired.

Scan Tool Does Not Communicate with Class 2 Device|Page 6789 > < Scan Tool Does Not Communicate with Class 2 Device|Page 6787