VUE FWD L4-2.4L Hybrid (2007)
9. Connect the fuel fill pipe vent tube and fresh air hose.
10. Tighten the intermediate bracket bolt.
Tighten the bolt to 10 N.m (89 lb in).
11. Install the inner wheelhouse liner.
12. Install the wheel and tire.
13. Connect the negative battery cable.
14. Lower the vehicle.
15. Perform the Service Bay Diagnostic Test for the EVAP emission system using the scan tool. This test will verify the integrity of the vapor handling
areas of the fuel system. See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes/Service
Bay Test
