VUE FWD L4-2.4L Hybrid (2007)
2. Connect the electrical connectors, the GPS antenna, and the cellular coax cable.
3. Tilt the CIM inboard and install the CIM.
Notice: Refer to Fastener Notice.
4. Install the CIM fastener.
Tighten the fastener to 10 N.m (89 lb in).
Important: After replacing the vehicle communication interface module, you must reconfigure the OnStar(R) system. Failure to
reconfigure the system will result in an additional customer visit for repair. In addition, pressing and holding the white dot button on the
keypad will NOT reset this version of the OnStar(R) system. This action will cause a DTC to set.
5. Reconfigure the OnStar(R) system. Refer to Control Module References for programming and setup information.