VUE FWD L4-2.4L Hybrid (2007)
Air Bag Control Module: Service and Repair
Inflatable Restraint Sensing and Diagnostic Module Replacement
Removal Procedure
Caution: Do not strike or jolt the inflatable restraint sensing and diagnostic module (SDM). Before applying power to the SDM, make
sure that it is securely fastened with the arrow facing toward the front of the vehicle. Failure to observe the correct installation procedure
could cause SIR deployment, personal injury, or unnecessary SIR system repairs.
1. Disable the SIR system. Refer to SIR Disabling and Enabling.
2. Remove the console assembly.
3. Remove the retainers from the connector position assurance (CPA) and disconnect the electrical connectors.
4. Remove the nuts and remove the sensing and diagnostic module (SDM).
Installation Procedure
1. Remove any dirt, grease, or other contaminants from the mounting surface.
Notice: Refer to Fastener Notice.
2. Install the SDM to the vehicle with the nuts.
Tighten the nuts to 10 N.m (89 lb in).
3. Install the console assembly.
4. Enable the SIR system. Refer to SIR Disabling and Enabling.
Important: If you do NOT perform the body control module (BCM) programming procedure, the vehicle option content information
