VUE FWD L4-2.4L Hybrid (2007)
Brake Switch (Cruise Control): Adjustments
Cruise Release Switch Adjustment
Notice: Improper cruise control release switch adjustment may cause brake damage such as brake drag, heat buildup and excessive brake lining
wear.
1. Disconnect the cruise brake switch harness connector.
2. Rotate the cruise brake switch counterclockwise and remove the cruise brake switch from the switch retainer.
Important: Do not depress the brake pedal assembly during the brake switch installation. Depressing the brake pedal will cause a brake
drag condition.
3. Install the cruise brake switch.
*
Position the switch into the retainer with the electrical connector index notch pointing to the 1 o'clock position.
*
Slide the switch in the retainer until the plunger is fully depressed into the barrel.
*
Rotate the switch clockwise until the travel stop has been reached, approximately 60 degrees.
*
Inspect the cruise brake switch to ensure the switch is properly locked into the switch retainer with the cruise brake switch electrical connector
index notch pointing to the 3 o'clock position.
