VUE FWD L4-2.4L Hybrid (2007)
Steering Gear: Service and Repair
Rack and Pinion Boot Replacement
Rack and Pinion Boot Replacement
Tools Required
SA9164C Clamp Crimper
Removal Procedure
1. Remove the power steering gear.
2. Loosen the outer tie rod jam nut.
3. Remove the outer tie rod from the inner tie rod. Count the number of turns during removal for installation.
4. Remove the spring from the boot, outer end.
5. Cut and remove the crimp clamp, inner end. Discard the clamp.
6. Unseat the boot from the steering gear and remove.
7. Clean the inner tie rod and boot contact area of grease and debris.
Installation Procedure
Important: The inner tie rod must be free of debris and moisture. The boot sealing areas must be clean and dry.
1. Apply approximately 3/4 of the supplied grease packet into the small end of the boot cavity. Apply the remainder of the grease on the shaft where
the small end of the boot meets the shaft.
Important: Ensure the large end of the boot is firmly seated in the gear housing groove.
