VUE FWD L4-2.4L Hybrid (2007)
Important:
*
Spray silicon lubricant on the insulators to aid in installation.
*
Ensure that part number identification tape located on the coil spring is oriented inboard of the vehicle and at the top of the
spring.
Position the spring with the rubber insulators into the vehicle.
2. Use a screw-type jackstand to compress the spring.
Notice: Refer to Fastener Notice.
3. Install the knuckle to the lower control arm.
Tighten the lower control arm to knuckle bolt to 110 N.m (81 lb ft).
4. Tighten the lower control arm to support nut and bolt.
Tighten the bolt to 110 N.m (81 lb ft).
