VUE FWD L4-2.4L Hybrid (2007)
Wiring Harness: Service and Repair
5AT - Automatic Transmission
Transmission Wiring Harness Extension Replacement
Removal Procedure
1. Remove the clutch pressure control solenoid cover.
2. Disconnect the shift control solenoid valve electrical connectors, noting proper location.
3. Remove the transmission wiring harness bolt and harness assembly.
Installation Procedure
1. Apply automatic transmission fluid to a new transmission wiring connector O-ring seal.
2. Install the new transmission wiring connector O-ring seal onto the transmission wiring harness assembly.
3. Install the transmission wiring harness assembly into the transmission case assembly through the wiring harness bore.
Notice: Refer to Fastener Notice.
4. Install the transmission wiring harness assembly bolt.
Tighten the bolt to 12 N.m (106 lb in).
5. Install the clutch pressure control solenoid cover.
